Support

Parts support

A straightforward way to source print-related consumables and replacement items for South African production floors.

How print parts supply fits into a working week

The parts desk page is for sourcing print-related consumables and replacement items used around production. It helps South African print teams identify what is needed for ongoing litho work and related equipment support.

Start with the exact machine, unit, and part description before sending a request. Include plate cylinder or feeder details, voltage where relevant, and whether the item is a wear consumable or a failed component. South African print rooms often run mixed Heidelberg, Polar, Stahl, and stitching equipment, so the model code matters as much as the part name.

Photos of the fitted item help avoid ordering the wrong revision. Note any error message, unusual noise, oil leak, feed issue, or intermittent stoppage seen during production. That gives the parts desk a clearer view of whether you need belts, grippers, bearings, sensors, rollers, or a compatible substitute.

Machine details that matter

The aim is a usable parts enquiry with the right identifiers attached. A good request includes the machine serial plate, the location of the failed item, and a note on what the operator observed before shutdown. That is more useful than a short message asking for a general spare.

Link the fault to the machine section when you write in through the contact form. Add the part position, any numbers stamped on the item, and whether this is for press, guillotine, folder, stitcher, or packing equipment. If another component was recently replaced, mention that as well because it can affect fitment and diagnosis.

  • Machine model, serial, and unit position
  • Clear photos of the failed item
  • Consumables and replacement part requests

Workshop conditions in South Africa

Dust, paper lint, and heat can shorten service life on sensors, suction lines, and moving assemblies. Long textbook and catalogue runs also put steady wear on delivery tapes, gripper pads, stitching heads, knives, and folding rollers. Parts planning needs to reflect the kind of production actually moving through the plant.

Coastal air can influence corrosion on metal components and affect how consumables are stored. Inland dry conditions often increase static around sheetfed equipment and feeder sections. Load shedding may interrupt fault tracing, so machine status, error codes, and the last change made should be written down before power shifts again.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

What to send with enquiries

List the required part with photos, machine details, and the fault already seen on site so the request matches the print equipment.

Include any old part number from the manual or removed component if it is still readable. When available, add a wide shot of the assembly and a close image of the damaged area.